Bowers & Wilkins CDA-16


Lisää kuvia

Saatavuus: Varastossa

2 000,00 €
Uusi monikanavapääte Bowers&Wilkins valmistajalta!


Our CDA-16 distribution power amplifier can drive any Bowers & Wilkins custom installation speaker to new heights of performance. Offering 16 channels of power, the CDA-16 can enable your whole home with sound yet takes up minimal space thanks to its compact 1U design. Its configurable specification supports bridging of its Class D stereo channels into even more powerful mono outputs, if needed. Load impedance range: Output Power per channel, non-clipped: Output Power bridge mode, non-clipped: Output Power total, all channels: DC offset voltage: Frequency Response (-3dB): Frequency response accuracy 20Hz-20kHz: Signal to Noise ratio (Ref. 50W/8Ω): THD+N (1kHz, 12.5W, 4Ω): Voltage Gain: Input impedance: Maximum input voltage: Signal sense threshold: Wake-up time: Turn-off time: 12V trigger input threshold: Controls & Indicators Front panel: Rear panel Connectors Input Output 12V trigger control Power Power consumption: AC supply: AC inlet: Thermal Thermal dissipation Dimensions Height: Width: Depth: Net weight: Finish >3Ω per channel (>6Ω in bridge mode) >50W into 8Ω >100W into 4Ω >200W into 8Ω >400W short term >200W continuous average <50mV <10Hz to >50kHz, any load impedance ±0.5dB >100dB A-Weighted typically 0.05% 34.9dB to - in nity, adjustable 15KΩ 6.8V peak (4.8V rms sine wave) 2.5mV (independent of Gain setting) <0.2s (If other zones active) <2s (From all zones inactive) 15 minutes from last signal detected typically 3V (recommended input is 5-15V) 1 x Power LED (unit active – White, Fault – Red) 8 x Zone status LEDs (Signal present – White, Fault – Red) 8 x 2-position DIP switches (link to global input) 1 x 3-position switch (power mode: on, auto detect, 12V trigger) 8 x input gain control with Clip indicator LEDs 8 x RCA (pair) Phono socket, line in (global in shared with Zone 8) 1 x RCA (pair) Phono socket (global out) 8 x 5.08mm Pitch 4-way Phoenix Combicon style 1 x 3.5 mm jack - 12V trigger IN 1 x 3.5 mm jack - 12V trigger OUT (Maximum 100mA pass-through) <0.5W All zones inactive <45W All zones idling 300W maximum average 1,000W peak 100-240V 50/60Hz IEC C14, switched 1.7 BTU/hr (standby), 150 BTU/hr (Idle), 400 BTU/hr (max) 44.5 mm (1.8in) 1U [55.5 mm (2.2in) plus feet] 437 mm (17.2in) 310 mm (12.2in) 4.5kg (9.9lb) Black


Paino: 4.5000
Väri: Black
Takuu 2 vuotta
Asennuspalvelu Meiltä myös suunnittelu- ja asennuspalvelu